IBM 4610-TM6 - SureMark Printer TM6 Two-color Thermal Transfer User Manual

10. For single-station SureMark printers, turn on the power on/off switch on the
printer.
11. For thermal/impact SureMark printers, locate the ribbon cartridge and install it
in the printer. (See “Ribbon loading” on page 51.) Be sure that the ribbon is
routed through the printhead correctly.
12. Load the paper roll into the printer. See “Paper loading” on page 53 for
thermal/impact SureMark printers or “Paper loading” on page 71 for
single-station SureMark printers.
13. Installation is now complete. Go to Chapter 5, “Testing and problem analysis
(Models TI1, TI2, TI3, TI4, TI8, TG3, and TG4),” on page 61 for thermal/impact
printers or Chapter 7, “Testing and problem analysis (Models TF6 and TM6),”
on page 75 for single-station printers and run the offline tests.
Installing SureMark for USB communication
1. Disconnect the power brick from the printer, if one is connected.
2. Locate the rear cable connectors on the printer.
Cash
Drawer
Port
Power
Supply
Port
Powered
USB Port
Standard
USB Port
Figure 9. USB Ports for Thermal/Impact SureMark Printers. (View is from the bottom rear of
the printer)
August 24, 2004
Chapter 2. Installation instructions 21

IBM 4610-TM6 - SureMark Printer TM6 Two-color Thermal Transfer Specifications

General

Brand	IBM
Model	4610-TM6 - SureMark Printer TM6 Two-color Thermal Transfer
Category	Printer
Language	English