IBM 4610-TM6 - SureMark Printer TM6 Two-color Thermal Transfer User Manual

Set left margin position (standard mode), set absolute print position
(page mode)
RS-485 Syntax:
X'1B;24;n1;n2'
RS-232 Syntax:
ESC $ n1 n2 or X'1B;24;n1;n2'
where:
v n1 is the high-order byte of the dot offset from the beginning of the print
line.
v n2 is the low-order byte of the dot offset from the beginning of the print
line.
Default:
n1 = 0, n2 = 0
Remarks:
v In the thermal station, 1 mm = 8 dots.
v In the impact station, 1 inch = 150 half-dots (75 dots).
v n1 and n2 are hex values. Convert each to decimal, and use this formula
to get the decimal equivalent: (n1 x 256) + n2.
v The maximum value in the thermal CR station is 576. The maximum
value in the impact DI station is 474.
v In the CR station, this number is rounded back to a factor of 8.
v If the n1,n2 vlaue exceeds the maximum, it is ignored.
v This command should be sent only after the command that selects the
station, Set print station (ESC c1 n).
v In Page mode, the printing position is moved the specified number of
dots from the beginning of the print line, in the same direction as printing,
specified by the Select printing direction/position command (X'1B;54...'). If
the print position is bottom-to-top, or top-to-bottom, this command adjusts
the print position in the vertical direction.
v This is a one-time adjustment on the current line. If this command moves
the print position outside the printable area specified by the Select
printable area command, it is ignored.
August 24, 2004
Appendix C. RS-232 programming information 181
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|

IBM 4610-TM6 - SureMark Printer TM6 Two-color Thermal Transfer Specifications

General

Brand	IBM
Model	4610-TM6 - SureMark Printer TM6 Two-color Thermal Transfer
Category	Printer
Language	English