IBM 4610-TM6 - SureMark Printer TM6 Two-color Thermal Transfer User Manual

v Information about your responsibilities when using USB communications has
been added to “Planning information” on page 8.
v The data rate for USB communications has been added to “Communication
interfaces” on page 9.
v USB information has been added to “Hardware requirements” on page 12.
v Information about installing the SureMark Printer for use with USB
communications has been added to “Installing SureMark for USB communication”
on page 21.
v Information about installing fillers for the SureMark Printer when the USB feature
is used has been added to “Installing fillers for USB printers” on page 27.
v Communication mode information for USB has been added to “USB
communication mode” on page 33.
v Relevant information for performing problem determination with USB has been
added to Table 3 on page 66.
GA27-4151-02
This edition includes information about two new models of the SureMark printer –
Model TI3 and Model TI4. Because Model TI3 is a new version of Model TI1, and
Model TI4 is a new version of Model TI2, in some cases only the new model
number was added to the existing text.
Information that was added includes:
v “Comparison of the SureMark models” on page 7, which describes the
microcode, hardware, and operating system differences.
v “Firmware update” on page 38, which describes the methods that you can use to
update the SureMark firmware.
v “Enable or disable the feed buttons (Models TI3, TI4, TI8, TG3, and TG4 only)”
on page 140 and “Set or cancel high-quality print mode” on page 130, which
describe new RS-232 commands.
Information
that was changed includes:
v “Software requirements” on page 13, which includes operating system and driver
requirements, and application requirements.
v “Code page definitions” on page 88. Code page 850, which is resident in Model
TI1 and TI2, has been replaced in this document by code page 858, which is
resident in Models TI3 and TI4. Code page 858 is the same as code page 850
plus the euro character symbol.
v Zero (0) is no longer valid for the RS-232 command “Microcode tolerance (MCT)
information - request” on page 123.
v The Remarks under “Define document wait time” on page 138 have been
corrected and expanded.
Because
documentation, drivers, and diskettes are now available on the Web,
“Resources on the Internet” on page 44 was added to describe how to locate the
applicable Web site.
Along with these changes and additions, the manual was also reorganized. The
information that was in Appendixes B and E, along with some additional information,
is now in Chapter 3, “SureMark installation, service, and utility software,” on page
35.
August 24, 2004
Summary of Changes xxi

IBM 4610-TM6 - SureMark Printer TM6 Two-color Thermal Transfer Specifications

General

Brand	IBM
Model	4610-TM6 - SureMark Printer TM6 Two-color Thermal Transfer
Category	Printer
Language	English