This ends the procedure.
UC235
For use by authorized service providers.
The problem may be that the card (a resource) was removed from the card enclosure without updating the
system configuration records.
Note: If the system has OptiConnect/400, verify that the remote system was powered on at the time of the
failure.
To update the system configuration records: Select: Hardware System Manager—> Logical Hardware
Resources—> System Bus Resources—>Non-reporting Resources—> Remove.
This
ends the procedure.
UC236
For use by authorized service providers.
The problem may be that the card (a resource) is not correctly plugged into the card enclosure.
Use the location information associated with this failing component in the Service Action Log entry and
verify that the card is installed properly.
UG3AS
For use by authorized service providers.
An error has been detected in iSeries Licensed Internal Code. Contact your next level of support for
possible corrective actions.
UJ0E7
For use by authorized service providers.
Local System Remote System
or Controller
.----------. .----------.
| | | |
| | | |
| | Local Modem Remote Modem | |
| | .-----------. .-----------. | |
| +----+ +------//------+ +----+ |
| | ’-----------’ ^ ^ ’-----------’ | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
’----------’ The problem is here. ’----------’
The problem has been isolated to the telephone line equipment that links the local and the remote
equipment.
UJ6P3
For use by authorized service providers.
An error occurred in the IBM Facsimile Support/400 Licensed Program. Please contact your next level of
support for possible corrective actions.
Find additional information on Facsimile Support for OS/400 in the Application System Facsimile Support
for OS/400 User’s Guide.
474 iSeries: iSeries Server 270, 800, 810, 820, 825, 830, 840, 870, 890, SB2, and SB3 Hardware Problem Analysis and
Isolation
To Next Page
Loading...
Need help?
General