configuration on the IBM 2105 ESS. The ESS Web Interface User’s Guide can also be found at the
following URL: http://ssddom02.storage.ibm.com/disk/ess/documentation.html
This
ends the procedure.
FC 5075 - Covers
For use by authorized service providers.
Use this procedure to remove or replace the covers on an FC 5075.
To remove or replace the covers:
v To remove the front cover, pull the top of the cover away from the frame.
v To remove the right side cover, unscrew the two thumbscrews at the rear of the tower and slide the
cover to the rear of the tower.
v To remove the rear cover, lift the cover to detach.
This
ends the procedure.
FC 5075 - Device board - DB1
For use by authorized service providers.
Use this procedure to remove or replace the device board - DB1 in an FC 5075.
To remove or replace a device board (DB1):
1. Power off the expansion unit. See the Expansion unit power procedure.
2. Unplug the power cord from the back of the expansion unit.
3. Remove the front and right side covers. See FC 5075 - Covers.
4. Remove the EMC shield in front of the disk units by pulling out on the two side latches.
5. Remove the disk units from the disk unit cage. Label the position of each disk unit.
6. Remove the screws holding the disk unit cage to the frame. The screws are located on the front and
inside rear of the disk unit cage.
7. Unplug and remove the cables plugged into the back of the device board.
8. Pull the disk unit cage out of the frame.
9. Remove the device board from the back of the disk unit cage.
10. Install the device board by reversing the removal procedure.
This
ends the procedure.
FC 5075 - Disk unit (concurrent)
For use by authorized service providers.
Use this procedure to remove or replace the disk unit (concurrently) in an FC 5075.
Attention: If removing the cover while the system is powered on, errors may occur due to electromagnetic
interference.
Attention: The disk unit is sensitive to electrostatic discharge. See Work with electrostatic
discharge-sensitive parts.
To remove or replace the disk unit (concurrent):
1. Determine if the system has logical partitions. Go to “Determine if the system has logical partitions” on
page 579, before continuing with this procedure.
2. Were you directed here from the Recovery procedures topic?
v Yes: Continue with the next step.
v No: Go to Recovery procedures.
158 Hardware (Remove and Replace; Part Locations and Listings)
To Next Page
Loading...
Need help?
General