2. Select an available 5U space in your rack to install the expansion enclosure.
Important notes:
v When you select a rack location, ensure that the enclosure and its parts are
easily accessible. Allow enough space for the lid to be easily removed and
for internal components, such as drives and secondary expansion modules,
to be serviced.
v When all components and drives are installed, the expansion enclosure is
heavy. Install the support rails and enclosure at the lowest available position.
Do not install the rails and enclosure above position U25 in the rack.
3. Remove the inner member of the rail. Push the tab (▌a▐) and slide the middle
rail member back, as shown in Figure 33.
4. Use four M4 screws to attach the inner rail to the side of the enclosure.
Figure 34 shows the screw locations.
5. Install the inner section of the rail onto each side of the expansion enclosure, as
shown in Figure 35 on page 51.
Pull tab forward
(a)
Push
x2
svc01080
Figure 33. Detaching the inner rail section
Figure 34. Screw locations to attach the inner rail to the enclosure
50 Storwize V5000 Gen2: Quick Installation Guide
To Next Page
Loading...
Need help?
General