IBM Storwize V7000 2076-224 User Manual

Table 6. Error messages and actions (continued)
Error code Error message Action key
O1BE Unable to distribute upgrade callback Check on health of
the cluster using
lshealth
Contact next level of
support.
01BF Upgrade callback failed Contact your
customer advocate.
Upgrade callbacks are
custom steps placed
on a system before the
start of upgrade.
Contact next level of
support.
01CF Unable to configure node Pull both power
supply cables from
subject node, wait 10
seconds, plug back in,
after system comes up
try again.
01C4 Unable to remove callbacks Contact next level of
support.
01D5 Storwize V7000 stalled. Contact your next
level of support.
01D6 Storwize V7000 stalled_non_redundant H
01DA GPFS cluster is unhealthy Refer to “Checking
the GPFS file system
mount on each file
module” on page 162
01DB Failed to stop performance center Please attempt to stop
performance center
using
/opt/IBM/sofs/cli/
cfgperfcenter --stop.
If successful restart
upgrade. If you are
unable to stop
performance center
please contact next
level of support .
Problems reported by the CLI commands during software
configuration
Use this information when troubleshooting problems reported by the CLI
commands during software configurations.
The following table contains error messages that might be displayed when running
the CLI commands during software configuration.
Chapter 3. Getting started troubleshooting 19

IBM Storwize V7000 2076-224 Specifications

General

Brand	IBM
Model	Storwize V7000 2076-224
Category	Storage
Language	English