a. Press down and out on the release lever on microprocessor socket 2 and
lift up the microprocessor release lever until it stops in the fully open
position.
b. Lift the hinged microprocessor bracket frame into an open position.
Attention: When you handle static-sensitive devices, take precautions to
avoid damage from static electricity. For details about handling these
devices, see “Handling static-sensitive devices” on page 32.
8. Install the microprocessor:
a. Remove the socket cover from the microprocessor socket.
b. Touch the static-protective package that contains the new microprocessor
to any unpainted metal surface on the server.
c. Remove the microprocessor installation tool assembly from the package.
The microprocessor installation tool assembly comes with the
microprocessor and microprocessor cover attached to the tool. The
microprocessor comes protected between the tool and the microprocessor
cover.
Attention:
v Do not rotate the handle on the tool until you are ready to install the
microprocessor into the microprocessor socket.
v Do not touch the microprocessor contacts; handle the microprocessor by
the edges only. Contaminants on the microprocessor contacts, such as oil
from your skin, can cause connection failures between the contacts and
the socket.
v Handle the microprocessor carefully. Dropping the microprocessor
during installation or removal can damage the contacts.
d. Remove the cover from the bottom of the microprocessor installation tool.
Press both microprocessor cover release tabs outward (in opposite
directions as shown in the illustration) and remove the microprocessor
52 System x3530 M4 Type 7160: Installation and Service Guide
To Next Page
Loading...
Need help?
General