6. Install the RAID adapter on the riser card and install the PCI riser-card
assembly in the server (see “Installing a PCI riser-card assembly” on page 45).
7. Connect the other end of the remote battery cable to the remote battery cable
connector on the battery carrier.
Attention: To avoid damage to the hardware, make sure that the black dot
on the remote battery cable connector faces away from the interposer card on
the adapter. Do not force the remote battery cable into the connector.
8. Route the remote battery cable in server as shown in the following illustration.
Attention: Make sure that the cable is not pinched and does not cover any
connectors or obstruct any components on the system board.
9. Install the battery on the safety cover:
a. Orient the battery as shown in the following illustration; then, lower the
battery onto the safety cover. If the battery comes with a battery carrier,
ensure that battery carrier posts align with the rings on the battery
mounting slot so that the battery carrier is secure in the slot.
Note: The positioning of the remote battery depends on the type of remote
battery that you install.
b. Rotate the retention clip to the close position and press down on the
retention clip until it snaps in place to hold the battery in place.
10. Connect the remote battery cable to the remote battery cable connector to the
ServeRAID adapter. Route the remote battery cable in the server as shown in
the following illustration.
Attention: Make sure that the cable is not pinched and does not cover any
connectors or obstruct any components on the system board.
If you have other devices to install or remove, do so now. Otherwise, go to
“Completing the installation” on page 65.
62 System x3530 M4 Type 7160: Installation and Service Guide
To Next Page
Loading...
Need help?
General