64
8
DSC OPERATION
■ Receiving DSC calls (Continued)
q When an Individual call is received:
• An alarm sounds.
• The following screen is displayed.
• The backlight blinks when the BAM
function (p. 20) is OFF.
w Push any [Close] .
• When the BAM function (p. 20) is
OFF: Push any [Alarm Off] .
e Select your desired action.
[Hold]: Holds the RX call task,
and return to the previous
screen.
[Able]: Sends an acknowledgment
without any changes.
[Accept]: Enters the DSC Task mode.
To send the acknowledgment,
push [Accept] .
DSC Task mode
•
Rotate [CH/ENT] to view the call
contents.
When you select [Accept] in step e,
you can send an acknowledgment
in the DSC Task mode. To send the
acknowledgment, go to step r.
If you return to the Main screen
without sending the acknowledgment,
go to step
i
.
NOTE: When the “Individual ACK” item
is set to “Auto (Unable),” the transceiver
automatically sends an acknowledgment.
Both the TX and RX calls are stored in the
Transmitted and Received Call Logs.
(pp. 75, 76)
r Push [≈] to scroll the Software Key
functions.
t Push the desired key to select an
acknowledgment option.
y
Push [Call]
to s
end the Individual
acknowledgment.
u Depending on the option selected
in step t, hold down [PTT] to
communicate.
i Push [Home]
to return to the
Main screen.
D Receiving an Individual call
TIP: When you send the
acknowledgment, select one of three
options, depending on your situation.
See page 50 for details of
the Individual acknowledgment
procedures.
To Next Page
Loading...
Need help?
General
