48
7
DSC OPERATION
■ Receiving DSC calls (other)
D Receiving an Individual call
NOTE:
• When the “Individual ACK” is set to “Auto (Able)”
or “Auto (Unable),” the transceiver automatically
sends an Acknowledgment “Able to comply” or
“Unable to comply.” (p. 57)
In that case, both the TX and RX calls are stored
in the Transmitted and Received Call Logs. (p. 54)
• To receive an Individual call, push [D-SCAN] to
enter the DSC watch mode. (p. 13)
When an Individual call is received:
• The alarm sounds until you turn it OFF.
• “Received Individual Call” is displayed.
1. Push to turn OFF the alarm.
2. Push the Software Key below the intended
operation.
: Ignores the call and returns to the Main
screen.
: Puts the RX task on hold, and returns
to the Main screen.
: Sends an Acknowledgment “Able to
comply” without any changes.
:
Enters the DSC Task mode immediately.
NOTE: When you select
in this step,
you can send an Acknowledgment in the DSC Task
mode. To send the Acknowledgment, go to step 3.
If you return to the Main screen without sending
the
Acknowledgment, go to step 7.
3. Push a key to select an Acknowledgment option.
• The Call Contents screen is displayed
4. Confirm the contents.
5. Push to send an Individual
Acknowledgment.
6. Hold down [PTT] to talk.
7. Push , and then to return to
the Main screen.
TIP: When you send the Acknowledgment, select
one of three options, depending on your situation.
See pages 36 and 37 for details of the Individual
Acknowledgment procedures.
Rotate
To Next Page
Loading...
Need help?
General
