Idex HALE SmartCAFS User Manual

Page 26 of 116
©HALE PRODUCTS, INC. Our policy is one of continuous development. We therefore
reserve the right to amend specifications without notice or obligation.
between the front and rear shafts changes every time the pump is used.
Maximum Recommended Driveline Lengths lists the maximum driveline length using a safety factor of
42% of critical speed. This table is based on a 0.134” (3.4 mm) wall thickness.
• Although wall thickness does not have a significant effect on drive shaft length for this
calculation, it does have some effect. Contact driveline supplier for additional information.
• Extremely short drive lengths between the pump and the rear axle can also cause problems
from excessive operating angles when the suspension articulates. Use caution and
conservative design values when utilizing air ride suspension and short rear drivelines.
• For application assistance and approval, contact a driveline equipment manufacturer, such
as Spicer/Dana or Meritor.
Position the unit onto the truck frame in the required location.
• Bolt the pump frame rails onto the truck frame. (DSD Unit pictured).
Figure 22: DSD Frame Rail Placement
Shaft
RPM
2.0 (51)
2.5 (64)
3.0 (76)
3.5 (89)
4.0 (102
4.5 (114)
2,400
47 (1,194)
53 (1,346)
58 (1,473)
63 (1,600)
76 (1,702)
71 (1,803)
2,600
45 (1,143)
51 (1,295)
55 (1,397)
60 (1,524)
64 (1,626)
68 (1,727)
2,800
44 (1,118)
49 (1,245)
53 (1,346)
58 (1,473)
62 (1,575)
65 (1,651)
3,000
42 (1,067)
47 (1,194)
52 (1,321)
56 (1,422)
60 (1,524)
63 (1,600)
3,200
41 (1,041)
46 (1,168)
50 (1,270)
54 (1,372)
58 (1,473)
61 (1,549)
3,400
39 (991)
44 (1,118)
48 (1,219)
53 (1,346)
56 (1,422)
59 (1,499)
3,600
38 (965)
43 (1,092)
47 (1,194)
51 (1,295)
55 (1,397)
58 (1,473)
3,800
37 (940)
42 (1,067)
46 (1,168)
50 (1,270)
53 (1,346)
56 (1,422)
4,000
36 (914)
41 (1,041)
45 (1,143)
48 (1,219)
52 (1,321)
55 (1,397)

Idex HALE SmartCAFS Specifications

General

Brand	Idex
Model	HALE SmartCAFS
Category	Water Pump
Language	English