Page 86 of 116
©HALE PRODUCTS, INC. Our policy is one of continuous development. We therefore
reserve the right to amend specifications without notice or obligation.
MAINTENANCE SCHEDULE FOR SMARTCAFS
NOTE: The HALE service intervals replace those in the Gardner Denver Compressor manuals.
Click below for Procedure W/ Internet
Hyperlinks or Internal Page Links
Check the pump and gearbox oil levels
Do a vacuum test to test for leaks
Check the oil level and top up if necessary.
Run compressor for 15 minutes
Check the drive belt tension and condition.
Grease air ratio control ball valve
Check that foam pipe connections are tight
Foam unit Manual FSG-MNL-00158
Operate the system in bypass to move the
concentrate and prevent gelling (if concentrate is
left in the system without use for three months)
Change the oil and oil filter
DSD Maintenance Manual 029-0020-93-0
Inspect the anode, replace if needed
DSD Maintenance Manual 029-0020-93-0
Inspect the anodes, replace if needed
Inspect wiring/connections, hoses/connections
Foam unit Manual FSG-MNL-00158
Verify water flow calibration
Verify foam feedback calibration
Replace the oil separator element
CAFS Maintenance & Repair Manual
101-2850-00-0
Replace the compressor drive belt
ATTENTION
In high usage or abnormal operating conditions, the above procedures may need to be more frequent.
The best practise is to flush the system after each use. Intervals are automatically tracked in the UV
Display under the maintenance tab.
To Next Page
Loading...
Need help?
General
