Page 55 of 116
©HALE PRODUCTS, INC. Our policy is one of continuous development. We therefore
reserve the right to amend specifications without notice or obligation.
(u) Auto-fill manual button
(When an auto-fill system is installed) The auto-fill manual button opens the KZCO valve
connected to the inlet in order to fill the water tank. This button is a momentary button and the
valve will only be open as long as the button is held. The on-screen icon changes to green to
indicate that the valve is being forced open.
(v) Auto-fill ON/OFF button
(When an auto-fill system is installed) The auto-fill ON/OFF button turns ON or OFF the
automatic water refill system. The on-screen icon shows the status of auto-fill: white = auto-fill
ON, white with RED / = auto-fill is OFF.
The auto-fill system will only operate if there is sufficient inlet pressure (7+ PSI). If there is not
enough inlet pressure the “NO INLET PSI” warning will be shown between the buttons.
(w) Menu button
Toggle button shows/hides the additional information displays. When this button is pressed
and held for 3 seconds it shows the password enter screen.
(x) Additional information display
The additional information displays show the total water flowed, total foam flowed, battery
voltage, pump engaged operating hours, and compressor oil temperature. This display is
toggle ON/OFF with the menu button.
NOTE: Total water flowed and total foam flowed are erased when the system is repowered.
These values may also be zeroed during operation when desired in the system menu.
To Next Page
Loading...
Need help?
General
