Page 70 of 116
©HALE PRODUCTS, INC. Our policy is one of continuous development. We therefore
reserve the right to amend specifications without notice or obligation.
WATER FLOW CALIBRATION (DIRECT)
The direct water flow calibration is simply a means of entering the values from a previous water
flow calibration without the need to actually flow water. The direct water flow calibration requires
the known values for the water flow value and its related water flow pulses (high and low) from a
previously completed calibration. This is typically used when having to replace the SmartCAFS
Controller or when another vehicle is determined to be exactly the same as a previous vehicle.
FOAM FLOW CALIBRATION
The foam flow calibration requires the discharge of a known quantity of foam concentrate into a
calibrated container.
NOTE: Be sure to set the foam bypass handle into the “bypass” position so that the discharged
foam concentrate may be collected.
1. Place the foam bypass handle into the “bypass” position.
2. Place the calibrated container so that it will be filled with foam concentrate as it is
discharged through the bypass hose.
3. Press the power button.
To Next Page
Loading...
Need help?
General
