Page 87 of 116
©HALE PRODUCTS, INC. Our policy is one of continuous development. We therefore
reserve the right to amend specifications without notice or obligation.
MAINTENANCE OPERATIONS PUMP – SMARTCAFS
CAFS MIXING MANIFOLD – GREASING BALL VALVE
The CAFS Mixing Manifold contains a ball valve as part of the air ratio control system.
This ball valve must be maintained by inserting lubricating grease at three monthly intervals to ensure
smooth and efficient operation.
LUBRICANTS:
Use one of the following lubricants. DO NO substitute other lubricants.
• Never-Seez - White Food Grade with PTFE, manufactured by:
Bostik Findley, Inc.
211 Boston Street
Middleton, MA. 01949-2128
Web: http://www.bostik-us.com
• White Knight tm - Food Grade Anti-Seize Compound, manufactured by:
Jet Lube Inc.
4849 Homestead Road
Suite 500
Houston, TX 77028
Web: www.jetlube.com
• Anti-Seize tm - manufactured by:
U.S. Valve Service & Training, Inc.
11875 West Little York
Suite 502
Houston, TX. 77041
Web: WWW.USVALVESERVICES.COM
Also see SVS Torrent Installation and Service Maintenance Manual, Hale p/n: 029-0020-90-0,
Section 4 “Routine Maintenance” for additional information.
The grease is inserted through one or two grease nipples. The first nipple is located on the side of the
valve facing the discharge end of the manifold. If a second nipple is fitted, it will be on the other side of
the manifold. Connect a suitable grease gun to the nipple and insert grease until a resistance is felt,
this indicates that sufficient grease has been inserted.
Figure 49: ARC VALVE
To Next Page
Loading...
Need help?
General
