Page 85 of 116
©HALE PRODUCTS, INC. Our policy is one of continuous development. We therefore
reserve the right to amend specifications without notice or obligation.
HOT SHIFT CLUTCH MAINTENANCE
NOTE: The hot shift clutch oil should be changed every 100 hours of operation or when the apparatus
engine oil is changed. (See Figure 48)
Figure 48: Hot Shift Operation
CHANGING CLUTCH OIL
1. Place a suitable container 12 to 14 ounces under the hot shift front clutch housing and remove the
brass drain plug.
2. Drain all oil then reinstall the brass drain plug.
3. Remove the brass fitting, containing the air vent, from the fill tube hose barb. (See Figure 48)
ATTENTION
DISPOSE OF THE WASTE WATER/OIL IN ACCORDANCE WITH YOUR LOCAL
RECYCLING
REGULATIONS.
4. Using a squeeze bottle or funnel, refill the housing via the hose barbed fitting and fill hose with
Dexron III or Mercon ATF or equal, while watching the oil level sight gauge. The housing holds
approximately twelve (12) ounces (0.4 liters). The proper oil level is when the oil level sight tube
is filled half way between the top and bottom.
WARNING
ALWAYS ALLOW OIL TO SETTLE PRIOR TO CHECKING LEVEL. DO NOT
OVERFILL THE
SYSTEM.
THE PROPER OIL LEVEL MUST BE MAINTAINED IN AT ALL TIMES. LOW OIL
LEVEL OR NO
OIL COULD RESULT IN EXCESSIVE OPERATING TEMPERATURES CAUSING MAJOR
DAMAGE. HIGH OIL LEVEL COULD CAUSE THE
SYSTEM TO MALFUNCTION OR COULD
CAUSE A DRIVE FAILURE.
To Next Page
Loading...
Need help?
General
