10 IDS805 USER MANUAL NO. 700-266-01A ISSUED NOV 2003 VER 1.00
IDS805 USER MANUAL
siyaledyrtnEyramirPehT.sdnoces
siyaledyrtnEyradnoceSehTsdnoces
siyaleDtixEehT.sdnoces
5. Arming the System
There are various options for arming the system
5.1 Away Arming Procedure
[#] + [USER CODE]
(Leave via Entry Exit Zone)
1. Ensure that the READY indicator is illuminated; if not, check
that all protected doors and windows are closed and that motion
has ceased in areas covered by motion detectors.
2. If necessary, close the front door.
3. Press the [#] key to cancel any unintended key entries.
4. Enter a valid 4 digit [USER CODE]. If you make a mistake, press
the [#] key and re-enter the code.
5. The ARMED indicator will illuminate and the keypad’s buzzer will
sound on and off for the duration of the exit delay. Any bypassed
zones will be shown by a steady illuminated zone indicator.
6. The arming process has begun. Leave only via the follower and
entry/exit zones.
7. The panel will arm at the end of the exit delay.
OR
If the panel is so programmed, violating the Push to Arm zone will
arm the panel immediately.
5.2 Quick Away Arming
[1]
(Hold down the key until the keypad buzzer sounds)
If this function is enabled, it is possible to AWAY arm by simply
holding down the [1] key until the keypad buzzer sounds and the
arming process begins.
To Next Page
Loading...
Need help?
General
