26 IDS805 USER MANUAL NO. 700-266-01A ISSUED NOV 2003 VER 1.00
IDS805 USER MANUAL
will also create a READY condition.
Does the installer need to reset the system?
Hold down the [7] key until the keypad buzzer sounds. If the zone 8
LED is illuminated contact your alarm installer immediately. It will not
be possible to arm the system until the installer mode has been
entered by entering the installer code.
Does the siren sound before you exit?
The exit delay may be too short - ask your installer to adjust the exit
delay.
OR
You have not left via a follower and entry/exit zone or have strayed into
an instant zone. Either avoid these zones or ask your installer to
change the zone type.
15.3 Problems when disarming the system
Does the siren sound immediately upon entry?
You have not entered via the entry/exit zone or have strayed into an
instant zone.
Does the siren sound before you get to the keypad?
You have strayed into a non-follower zone
OR
You have taken too long to get to the keypad.
The panel will not disarm?
You may have entered an incorrect code.
Press the [#] key first, then re-enter your user code.
15.4 For Service
Central Station Information:
:#tnuoccAenohpeleT
Installer Information:
:#tnuoccAenohpeleT
To Next Page
Loading...
Need help?
General
