IDS805 USER MANUAL NO. 700-266-01A ISSUED NOV 2003 VER 1.00 11
IDS805 USER MANUAL
5.3 Stay Arming Procedure
This allows the user to arm the perimeter zones while disabling the
interior zones so that it is possible to remain on the premises. If zones
are likely to be violated accidentally, they should be programmed as
BUZZ zones (refer to page 22). The panel can be programmed with two
different STAY PROFILES to be used as required. Following is an
example of where this may be used. Assume a property has perimeter
sensors to secure a garden fence and a number of internal sensors
within each room of the house.
The first STAY PROFILE would function as follows: At night while you
are within the house going about your normal evening activities it may
be desirable to activate the alarm such that any violation of the
perimeter sensors will cause an alarm. Therefore this profile would
have all internal sensors programmed as STAY zones (bypassed) and
perimeter sensors would be normal alarm zones.
A second STAY PROFILE would then be utilised once the family
retires to their bedrooms. All bedrooms would therefore be STAY
zones (bypassed) while unused zones i.e. a lounge and TV room,
together with perimeter zones would be normal alarm zones.
NOTE:
Once a particular stay profile is selected the system will use the
selected profile each time the system is armed into the STAY MODE.
If the alternate profile is required it is necessary to select the alternate
profile before the system is armed.
The arming procedures and quick keys will have effect on the selected
profile. STAY and BUZZ zones can be programmed for each profile once
the profile has been entered.
5.3.1 To Enter a Stay Profile
[#] + [MODE] + [9] + [PROFILE NUMBER] + [
!!
!!
!]
1. Press the [#] key to clear any previous entries.
2. Press [MODE].
To Next Page
Loading...
Need help?
General
