24 IDS805 USER MANUAL NO. 700-266-01A ISSUED NOV 2003 VER 1.00
IDS805 USER MANUAL
14.1 To Program the Chime Zones
[2] + [ZONE NUMBER] + [
!!
!!
!] + [#]
1. Hold down the [2] key until the keypad buzzer sounds.
2. The AWAY indicator will flash to show that the panel is In the
chime zone programming mode.
3. To program a zone as a chime zone, press the key corresponding
to that zone followed by the [
!!
!!
!] key. The zone indicator will
illuminate.
4. Program any other zones you wish to select as chime zones as
per step 3.
5. Press the [#] key to exit the chime programming mode.
14.2 To Cancel the Chime Zones
[2] + [ZONE NUMBER] + [
!!
!!
!] + [#]
1. Hold down the [2] key until the keypad buzzer sounds.
2. The AWAY indicator will flash to show that the panel is on the
chime programming mode.
3. To cancel any chime zones, press the key corresponding to that
zone followed by the [
!!
!!
!] key. The zone indicator will extinguish.
4. Press the [#] key to exit the chime programming mode.
NOTE:
The system will automaticaly exit this mode after 60 seconds.
15. Trouble-Shooting
15.1 Trouble Conditions
In the event of a trouble condition the power indicator will flash. Trouble
Condition refers to Low Battery power and/or AC Mains Failure. Check
that the plug is in place and switched on. If the power indicator is still
flashing once these checks have been done, contact your installer who
will then check the battery power.
To Next Page
Loading...
Need help?
General
