To Next Page

To Previous Page

14 IDS805 USER MANUAL NO. 700-266-01A ISSUED NOV 2003 VER 1.00

IDS805 USER MANUAL

5.8 Arming with Entry/ exit or Follower Zones Violated

The system can be programmed to arm even if the entry/ exit or

follower zones are violated. Follow the normal arming procedures i.e.

Enter a valid [USER CODE], but it is not necessary to close the front

door.

5.9 Forced Arming

If so programmed, the panel can be armed even if there are violated

zones. This means that a monitored window can be left open or other

zones can be violated and the panel will still arm. If the violated zone is

then cleared, the panel will resume monitoring the zone, hence

causing an alarm condition or initiation of entry delay, as appropriate, if

violated.

6. Zone Bypassing

! The term BYPASS is used to describe a zone that has been de-

activated; i.e. violation of a bypassed zone will not cause an

alarm.

! It is used when:

! access is needed to part of the protected area while the

system is armed.

! Zones cannot be bypassed once the system is armed.

! Bypassed zones are automatically cancelled each time the

system is disarmed and must be re-bypassed before the next

arming.

6.1 To Bypass a Zone

[

!] + [ZONE NUMBER]

1. Press the [

!] key (while bypassing zones, violated zones will be

flashing).

2. Press the number corresponding to the zone you need to by-

pass e.g. the [2] key if you wish to bypass zone 2.

3. The relevant zone indicator will illuminate to indicate that the zone

IDS IDS805 User Manual

Other manuals for IDS IDS805