To Next Page

To Previous Page

IDS805 USER MANUAL NO. 700-266-01A ISSUED NOV 2003 VER 1.00 21

IDS805 USER MANUAL

11.3 Maids Code

The maids code (user 14) may be used to limit access to the

premises. The maids code will only disarm the system if the same

code was used for arming. If armed with a code other than a maids

code, the system will view an attempt to disarm with the maids code

as an invalid entry. Any valid user code will disarm the system if it has

been armed with the maids code.

EXAMPLE:

If a maid is expected on a Monday, arming the system on a Monday

morning using the maids code will allow the maid to disarm the

system. On days that any other user code (i.e. not a maids code) has

been used to arm the system entering the maids code will not disarm

the system.

12. Stay Zones

Stay zones are those zones which are bypassed automatically when

the system is STAY ARMED. To avoid triggering the alarm, zones

such as bedrooms, or other areas which require access, must be

bypassed. Stay zones need only be programmed once. Each time the

system is armed in the stay mode the preselected stay zones will be

bypassed automatically.

12.1 To Program Stay Zones

[3] + [ZONE NUMBER] + [

!] + [#]

1. Hold down the [3] key until the keypad buzzer sounds. The

AWAY indicator will flash to show that the panel is in the Stay

Zone programming mode.

2. Press the [NUMBER] corresponding to the zone you wish to be a

STAY zone followed by the [

!] key.

3. The relevant zone indicator will illuminate. (Buzz zones will be

shown by flashing indicators. See Section 13. A Buzz zone

cannot be selected as a Stay zone; the Buzz status must be

cleared first.)

4. Repeat step 2 until all stay zones are selected.

IDS IDS805 User Manual

Other manuals for IDS IDS805