16 IDS805 USER MANUAL NO. 700-266-01A ISSUED NOV 2003 VER 1.00
IDS805 USER MANUAL
! If the entry period is too short, have your installer change the
entry delay period.
! If four incorrect user codes are entered consecutively while either
arming or disarming the system, the keypad will be non-
responsive for 30 seconds. Your monitoring company will also be
notified on a keypad tamper.
NOTE:
If the ARMED indicator is flashing upon entry, there has been a
violation. The intruder may still be inside! Call for assistance.
NOTE:
If a strobe (or flashing light) has been installed and an alarm condition
is registered the light will continue flashing after the siren has stopped
sounding. Entering a valid [USER CODE] will cancel the strobe.
7.2 To Disarm with a Key-Switch or Remote Control
1. Press the remote button or twist and release the key-switch.
2. The system will disarm and the remote indicator (if installed) will
extinguish.
3. If programmed to do so, the siren will sound briefly - verify with
your installer.
8. Emergency Situations
8.1 Fire Alarm
[F]
(Hold down the key until the keypad buzzer sounds)
! If the [F] key is pressed until the keypad beeps (approximately 1
second) a FIRE ALARM condition will be activated.
! The FIRE ALARM CONDITION can also be triggered by a smoke
detector connected to an appropriately programmed zone.
! The siren will sound and the FIRE REPORTING CODE will be
transmitted to the monitoring company.
! To silence the siren enter a 4 digit [USER CODE]. The siren will
stop sounding after 10 minutes if no user code is entered.
To Next Page
Loading...
Need help?
General
