IDS805 USER MANUAL NO. 700-266-01A ISSUED NOV 2003 VER 1.00 13
IDS805 USER MANUAL
This is a quick function which allows the user to STAY arm and leave
the premises.
1. Hold down the [6] key until the keypad buzzer sounds. The
keypad buzzer will now sound on and off for the duration of the
exit delay
2. At the end of the exit delay the ARMED indicator will illuminate
and the AWAY indicator will remain extinguished. Any stay zones
will be bypassed.
3. Be sure to leave only via the follower and entry/exit zones.
5.6 Arming from a Key-Switch or Remote Control
There are several option related to this function. Verify with your
installer which of the following have been installed:
" Key-Switch or Remote Control installed
" Exit Delay with Key-Switch or Remote Control
" Siren toot on Arm
" Siren on toot Disarm
1. Ensure that the READY indicator is illuminated before leaving.
2. Leave and close the door (remembering to lock!).
3. Press the remote button or twist and release the key-switch.
4. The alarm will arm immediately and the remote ARM indicator
will illuminate.
OR
If an exit delay has been enabled, the exit delay will begin.
5. If programmed to do so, the siren will sound briefly - verify with
your installer.
NOTE:
If a remote control is used, it is advisable to have the siren sound on
arm and disarm function enabled.
5.7 Auto-Arming
Your system can be programmed to automatically arm itself daily at a
preprogrammed time. Ask your installer to program this function if
required. Should the premesis be occupied at the auto-arming time, a
valid [USER CODE] entered during the 3 minute arming cycle will
cancel the process.
To Next Page
Loading...
Need help?
General
