To Next Page

To Previous Page

IDS805 USER MANUAL NO. 700-266-01A ISSUED NOV 2003 VER 1.00 23

IDS805 USER MANUAL

2. Hold down the [4] key until the keypad buzzer sounds. The

AWAY indicator will flash to show that the panel is armed in the

Buzz Zone programming mode.

3. Press the [NUMBER] corresponding to the zone you wish to be a

Buzz zone followed by the [

!] key.

4. The relevant Buzz zone will be shown by the illuminated zone

indicator. (Stay zones will be shown by flashing indicators. See

Section 12. A Stay zone cannot be selected as a Buzz zone; the

Stay status must be cleared first).

5. Repeat steps 1-3 until all the required Buzz zones are

programmed.

6. Press the [#] key to exit the buzz programming mode.

13.2 To Cancel Buzz Zones

[4] + [ZONE NUMBER] + [

!] + [#]

1. Ensure that the READY indicator is illuminated.

2. Hold down the [4] key until the keypad buzzer sounds. The

AWAY indicator will flash to show that the panel is armed in the

Buzz Zone programming mode.

3. Press the [NUMBER] corresponding to the BUZZ zone you wish

to cancel followed by the [

!] key.

4. The relevant zone indicator will extinguish.

5. Press the [#] key to exit the buzz zone programming mode.

NOTE:

The system will automatically exit this mode after 60 seconds.

14. Chime Zones

The chime mode allows the user to monitor nominated zones while the

system is disarmed. The keypad buzzer will sound briefly when the

nominated zone is violated - the siren will NOT sound and no alarm

condition will be reported.

EXAMPLE:

You wish to know when someone enters or exits the front door, the

keypad will beep each time the door is opened if that zone is

programmed as a chime zone.

IDS IDS805 User Manual

Other manuals for IDS IDS805