Integra DHC-80.3 User Manual

38
En
About Listening Modes
The AV controller’s listening modes can transform your listening room into a movie theater or concert hall, with high
fidelity and stunning surround sound.
■ Explanatory Notes
Input Source
The following audio formats are supported by the listening mode.
Speaker Layout
The illustration shows which speakers are activated in each channel. See “Speaker Configuration” for the speaker setup
(➔ page 53).
*1
Note that these layouts can only be selected when “Front High + Front Wide” is set to “No” (➔ page 52).
*2
To use this layout, set “Front High + Front Wide” to “No” (➔ page 52) and enable “Surround Back” (➔ page 53).
*3
To use this layout, set “Front High + Front Wide” to “Yes” (➔ page 52).
ij
gh
kl
cb
a
f
de
abFront speakers
c Center speaker
deSurround speakers
f Subwoofer(s)
ghSurround back speakers
ijFront high speakers
klFront wide speakers
Listening
mode buttons
A
This is mono (monophonic) sound.
S
This is stereo (stereophonic) sound. Two independent audio signal channels are reproduced through two speakers.
D
This is 5.1-channel surround sound. This surround system has five main channels of sound and a sixth subwoofer
channel (called the point-one channel).
F
This is 7.1-channel surround sound. This is a further sound enhancement to 5.1 channel sound with two additional
speakers that provide greater sound envelopment and more accurate positioning of sounds.
G
This is DTS-ES surround sound. This surround system can produce a discrete or a matrix-encoded sixth channel from
existing DTS 5.1 encoded material.
H
This is Dolby Digital EX surround sound. This provides a center back surround channel from 5.1-channel sources.
nm
zxc
}
*
+
,
/
.
*1 *1 *2 *1 *1 *3

Integra DHC-80.3 Specifications

General

Brand	Integra
Model	DHC-80.3
Category	Controller
Language	English