70
En
With this preference, you can protect your settings by
locking the setup menus.
Main menu Lock Setup
■ Setup
` Locked
` Unlocked
When “Locked” is selected, the setup menus will be
locked and you cannot change any setting.
You can change various audio settings from the Home
menu (➔ page 44).
Note
• These settings are not available in either of the following cases:
–the “Audio TV Out” setting is set to “On” (➔ page 67).
–“HDMI Control(RIHD)” is set to “On” (➔ page 67) and
you’re listening through your TV speakers.
Sound Program
■ Sound Program
` Stereo Source 1, Stereo Source 2, Stereo Source 3,
Multich Source 1, Multich Source 2, Multich
Source 3
` Off
With this setting, you can select the combination of
settings that you registered in “Sound Program Edit”
(➔ page 58).
Note
• This setting is not available when the multichannel analog input
is selected.
• If the input selector is changed, the “Sound Program” setting is
switched back to “Off”.
Tone Control Settings
■ Bass
` –10dB to 0dB
to +10dB in 2 dB steps.
You can boost or cut low-frequency sounds output.
■ Treble
` –10dB to 0dB
to +10dB in 2 dB steps.
You can boost or cut high-frequency sounds output.
You can adjust the bass for the front, front wide, front
high, center, surround, surround back and subwoofer
speakers and treble for the front, front wide, front high,
center, surround and surround back speakers, except when
the Direct or THX listening mode is selected.
Operating on the AV controller
Note
• This setting is not available when the multichannel analog input
is selected.
Speaker Levels
■ Subwoofer 1
` –15.0dB to 0.0dB
to +12.0dB in 0.5 dB steps.
■ Subwoofer 2
*1
` –15.0dB to 0.0dB to +12.0dB in 0.5 dB steps.
■ Center
` –12.0dB to 0.0dB
to +12.0dB in 0.5 dB steps.
You can adjust the volume of each speaker while listening
to an input source.
These temporary adjustments are cancelled when the AV
controller is set to standby. To save the setting you made
here, go to “Level Calibration” (➔ page 54) before
setting the AV controller to standby.
Note
• You cannot use these functions while the AV controller is
muted.
• These settings cannot be used while a pair of headphones is
connected.
• Speakers that are set to “No” or “None” in
“Speaker Configuration” (➔ page 53) cannot be adjusted.
*1
If the “Subwoofer” setting is set to “1ch”, this setting cannot
be selected (➔ page 53).
Lock Setup
Using the Audio Settings
1
Press Receiver followed by Home.
2
Use q/w and Enter to select “Audio”, and then use
q/w/e/r to make the desired selection.
1
Press Tone repeatedly to select either “Bass” or
“Treble” for each speaker or subwoofer.
2
Use + and – to adjust.
To Next Page
Loading...
Need help?
General
