Inspection and Installation
2.3 Rack Mounting
This instrument can be installed on standard 19-inch rack. ITECH has prepared
the IT-E158 bracket as a mounting kit for users. Users can select the corre-
sponding bracket manual for installation according to the specific bracket model
purchased.
2.4 Connecting the Power Cord
Precautions
To prevent electric shock and damage to the instrument, observe the following
precautions.
• The power cords supplied with this product is certified for safety. In
case the supplied lines assembly needs to be replaced, or an exten-
sion lines must be added, be sure that it can meet the required
power ratings of this product. Any misuse voids the warranty of
this product.
• Before connecting power cord, be sure to confirm that the power
voltage matches with the supply voltage. Make sure that the posi-
tion of the voltage switch on the left side of the instrument is con-
sistent with the actual power supply voltage.
• Before connecting power cord, be sure to switch off the instrument.
Power switch is in Off position.
• To avoid fire or electric shock, make sure to use the power cord
supplied by ITECH.
• Do not use an extended power cord without protective grounding,
otherwise the protection function will fail.
• Be sure to connect the main power socket to the power outlet with
protective grounding. Do not use terminal board without protective
grounding.
Categories of Power Cords
IT-M3140 series power supply provides the standard power cords as below.
Copyright © Itech Electronic Co., Ltd.
19
To Next Page
Loading...
Need help?
General
