Functions and Features
a. Select Current or Voltage to set the current or voltage value.
b. Select Slope to set the slope of the step.
c. Select Time to set the dwell time of the step.
d. Select Next to set whether to edit the next step. If set to Yes, repeat
steps a through c to set the parameters for next step. If set to No, the list
step parameters setting is over.
8. If you need to continue to adjust the list step, you can use the following set-
tings to insert, add or delete steps.
• If you need to insert steps, select Insert Step and press [Enter] key to
confirm. Use knob to set the insert location and press [Enter] key. Re-
peat steps 7a through 7d to set the parameters for the inserted step. The
inserted step is before each specified step and you can insert multiple
steps continuously.
• If you need to add steps, select Add Step and press [Enter] key to con-
firm. Use knob to set the add location and press [Enter] key. Repeat
steps 7a through 7d to set the parameters for the added step. The added
step is after each specified step and you can add multiple steps
continuously.
• If you need to delete steps, select Delete Step and press [Enter] key to
confirm. Use knob to set the delete location and press [Enter] key.
• If you need to delete all steps, select Delete all and press [Enter] key to
confirm. Use knob to select Yes and press [Enter] key.
4.4.2 Copy List Program
For an existed list program, you can copy and name it a new list program. Then
you can edit the new list program, insert steps or delete steps. This function sim-
plifies the edit operation for similar list program. The operation steps are as
follows.
1. Press [Shift]+[I-set] (Function) to enter function menu interface.
2. Use left and right keys or rotate the knob to select List and press [Enter]
key to confirm.
3. Use left and right keys or rotate the knob to select Edit List and press
[Enter] key to confirm.
4. Use knob to set the list program name and press [Enter] key to confirm.
5. Select Copy File X to X and press [Enter] key to confirm.
6. Use knob to select setting source
List program name and target List program
name and press [Enter] key to confirm.
4.4.3 View List Program
Before selecting and running the list program, you can view the related parame-
ters and each step of the existed list program. The operation steps to view the
list program are as follows.
Copyright © Itech Electronic Co., Ltd.
60
To Next Page
Loading...
Need help?
General
