Functions and Features
Save Operations
1. Press [Save] to enter into the saving interface.
2. Set the storage location.
Use knob to adjust a value from 1 to 10 on the prompt interface “Save File =
1” to set the storage location in non-volatile memory.
3. Press [Enter] key to confirm.
Recall Operations
You can recall the parameters you saved in the specified memory location as
the setting values.
1. Press [Recall] to enter into the saving interface.
2. Set the recall location.
Use knob to adjust a value from 1 to 10 on the prompt interface “Recall File
= 1” to set the recall location in non-volatile memory.
The second lines displays the stored voltage and current values in the speci-
fied memory location
3. Press [Enter] key to confirm the recall operation.
4.3 Protection Function
This series power supplies provide the following protection functions. You can
set these functions in the Protect menu.
• The maximum output voltage setting value (U-Max) and the minimum output
voltage setting value (U-Min), these functions limit the setting value of the
output voltage and current from front panel.
• Over-voltage protection, over-current protection, over-power protection,
under-voltage protection, under-current protection and over-temperature
protection, these functions disable the output to protect the device under test
(DUT), as well as the power supply.
4.3.1 Set the Setting Value Limit Protection
To avoid causing damage to the DUT, after you set the U-Max and U-Min, the
setting value from the [V-set] key on the front panel can’t exceed the setting
limit.
The operation steps are as follows.
Copyright © Itech Electronic Co., Ltd.
49
To Next Page
Loading...
Need help?
General
