jcb 19C-1E User Manual

Operation
Fire Extinguisher
Fire Extinguisher
General
Location
The fire extinguisher is located behind the seat and is held in position by a stowage bracket. Refer to: Operator
Station (Page 15).
Keep the fire extinguisher in this position until you need to use it.
Operation
WARNING Do not use the fire extinguisher in a confined space. Make sure that the area is well ventilated
during and after using the fire extinguisher.
WARNING After any use, the extinguisher must be replaced or serviced.
Make sure that you understand how to use the fire extinguisher. If necessary, refer to the instructions found
on the fire extinguisher.
Only try to extinguish a fire if the circumstances permit and your safety is not endangered. If necessary, contact
your nearest fire department.
Using the fire extinguisher:
1. If the circumstances permit and your safety is not endangered, move the machine to a safe place to prevent
the fire from spreading.
2. Remove extinguisher from its stowage bracket.
3. Remove safety pin.
4. Aim directly at the fire from an upwind position, if possible.
5. Squeeze trigger to operate the extinguisher, release the trigger to stop the flow.
Figure 54.
B
A
A Safety pin B Trigger
69 9831/8250-4 69
JCB © Admin Pimteam - 23/06/2021 05:32.

jcb 19C-1E Specifications

General

Battery Type	Manganese laminated Lithium-ion
Battery Rated Capacity	14.8 kWh (3 Pack) 19.8 kWh (4 Pack)
Charging	On-board charger with direct connection from AC mains power supply
Charging Time	110V – 12 hrs 230V – 8 hrs
Fast Charging (Optional)	Off-board charger, with connection to 415V 3-Phase supply Charging time <2 hrs
System Voltage	48V
Motor Type	AC permanent magnet
Motor Power	7 kW continuous 20kW peak
Operating Modes	L – 1200rpm G – 1600rpm H – 1800rpm Auto Kick Up – 2300rpm, 2 speed tracking only
Thermal Limitations	Operation: -10oC to +46oC Charging: -10oC to +40oC