Optional Attachments
Introduction
252 252
9811/9950-1
This part of the manual includes general information on
attachment operation and instructions for installation and
removal of attachments.
Some attachments are supplied complete with instructions
on safety, installing and removing, operation and
maintenance. Read and fully understand the information
before fitting, using and servicing the attachment. If there
is anything you do not understand, ask your JCB
Distributor.
Before using any attachment, read again Working With
The Machine in the Operation section and consider how
the attachment is going to affect operational safety. With
the attachment fitted, there may be changes in the
machine's centre of gravity or overall dimensions. This
could have an effect on, for example, machine stability, the
gradients on which it is safe to operate or the safe distance
from power lines.
Practice using attachments off the job before working with
them for the first time.
JCB attachments are designed and manufactured
specifically to suit the machine's hydraulic system,
mounting arrangements and safe load requirements.
Attachments which are not designed for use with this
machine may cause damage and create safety hazards for
which JCB cannot be held responsible. In addition the
machine's warranty and any other legislative compliance
may be affected by the use of non JCB approved
attachments.
If your machine needs the hydraulic system adapting to
facilitate the use of auxiliary attachments, you must consult
your distributor. Only suitably qualified personnel must re-
route hydraulic hoses.
All optional attachments will have limits on their operation.
i.e. lifting capacity, speeds, hydraulic flow rates, etc.
Always check in the literature supplied with the attachment
or in the Specification section of this manual. Some
specification limits may also be displayed on the
attachments Data/Rating Plate.
To Next Page
Loading...
Need help?
General
