JUKI IP-110 Type F User Manual

- 22 -
14. SIMPLIFIED FUNCTION SETTING
Function setting items can be simplied in part.
1) Keeping thread trimming prohibiting switch
1
held pressed, turn the power ON. Then, the
screen is changed over to the simplied func-
tion setting screen. The details displayed on the
screen represent the current settings.
2) Function items can be changed by pressing
switches
2
and
3
,
4
and
5
or
6
and
7
.
[Simplied function setting screen]
3 1
642
5 7 8
* Wiper function (WiP): Switches
2
and
3
This function activates the wiper.
oFF : The wiper does not operate after thread trimming.: The wiper does not operate after thread trimming. The wiper does not operate after thread trimming.
on : The wiper operates after thread trimming (standard setting at the time of delivery): The wiper operates after thread trimming (standard setting at the time of delivery) The wiper operates after thread trimming (standard setting at the time of delivery)
* Auto-lifter (FL): Switches
4
and
5
This function activates the auto-lifter function when the presser foot lifting device (AK) is installed on the
sewing machine.
For the presser foot lifting device specications, solenoid drive mode (+33 V) or air drive mode (+24 V)
can be selected.
The drive source voltage (CN37) is changed over between +33 V and + 24 V according to the drive
mode specication selection.
oFF :: Auto-lifter does not operate. (standard setting at the time of delivery)
(The presser foot does not automatically go up when the program sewing is completed.)
on S :: Auto-lifter operates. (Solenoid drive mode [+33 V])
on A :: Auto-lifter operates. (Air drive mode [+24 V])
* Needle position changeover function for the time when the sewing machine stops (nP): Switches
6
and
7
The needle position at the time when the sewing machine stops can be changed over.
Lo : Lower stop position (standard setting at the time of delivery): Lower stop position (standard setting at the time of delivery) Lower stop position (standard setting at the time of delivery)
UP : Upper stop position: Upper stop position Upper stop position
3) Once you have completed the setting, press switch
8
. The screen is changed over to the power switch
OFF notication screen.
[Power switch OFF notication screen]
4) Turn OFF the power switch to exit from the sim-
plied function setting.
If "on" (auto-lifter operates) is selected without the auto-lifter installed, the machine startup is mo-
mentarily delayed at the beginning of sewing. In addition, the one-touch type reverse feed (touch-back)
switch may be disabled. To avoid these troubles, be sure to select "oFF" (auto-lifter does not oper-
ate) when the auto-lifter device is not installed.
WARNING :
If the solenoid is used under the air drive mode, the solenoid can burn out. Be sure to carefully avoid
the wrong setting of the presser foot lifting device specication.

JUKI IP-110 Type F Specifications

General

Brand	JUKI
Model	IP-110 Type F
Category	Sewing Machine
Language	English