Jungheinrich ERC 214 User Manual

8.1.4 Changing the master code
Z
To change the length of the master code you must follow the procedure in
"Changing the master code", see page 116. If there are still user codes stored in the
code lock, the master code to be changed must be the same length as the saved
user codes.
Requirements
– To prepare the truck for operation, see page 74.
Procedure
• Press the O key (77).
• Enter the valid master code with the digit keys.
When you enter the valid master code the LED
(76) flashes green.
• Enter the parameters 0-0-0 with the digit keys.
• Confirm with the SET key (75).
The LEDs (72,76) flash green.
• Enter the valid master code again with the digit keys.
• Confirm with the SET key (75).
The LEDs (73,76) flash green.
• Enter the valid master code with the digit keys.
Z
The new master code must be different from existing user codes.
• Confirm with the SET key (75).
The LEDs (74,76) flash green.
• Enter the new master code again with the digit keys.
• Confirm with the SET key (75).
Wait until the LED (76) flashes green. The setting is saved.
• Press the O key (77).
The truck is switched off and the LED (76) is lit red.
• Check the new master code:
• Switch on the truck with the new master code, see page 116
When you enter the valid master code the LED (76) flashes green.
• Press the O key (77).
The truck is switched off and the LED (76) is lit red.
75
72
73
74
77
76
116
04.19 en-GB

Jungheinrich ERC 214 Specifications

General

Brand	Jungheinrich
Model	ERC 214
Category	Forklifts
Language	English