8.9.2 Activating the transponder reader
Procedure
• Release the emergency disconnect
switch, see page 80.
• Enter the default code 1-2-3-4 using the
keys below the display unit (55).
The truck is switched on.
• Press the key below the "Settings"
symbol (93).
• Press the key below the "Change set-
up code" symbol (94).
• Enter the set-up code 2-4-1-2 using the
keys below the display unit (55).
The set-up code entered is displayed.
• Press the key below the "Delete"
symbol (95).
The set-up code is deleted.
• Hold a transponder in front of the
transponder reader (92).
This transponder thus becomes the set-
up transponder.
• Press the key below the "Confirm"
symbol (96).
The code for the set-up transponder is
displayed.
Z
If the wrong transponder has been used,
the procedure can be repeated using the
key below the "Delete" symbol (95).
• To return to the main menu, press the
key below the "Back" symbol (97).
Z
The default code can no longer be used
and must be deleted.
Delete the default code, see page 166.
• Add new transponders, see page 165.
The transponder reader is now active.
152
04.19 en-GB
To Next Page
Loading...
Need help?
General
