Jungheinrich ERC 214 - Page 167

8.12.4 Adding a new transponder
Requirements
– The truck is switched on, see
page 163.
Procedure
• Press the key below the "Settings"
symbol (93).
• Press the key below the "Edit
transponder" symbol (99).
The set-up transponder is requested.
• Place the set-up transponder on the
transponder reader (92).
All transponder codes are shown on
the display unit (55).
• Press the key below the "Add"
symbol (100).
• Place the new transponder on the
transponder reader (92).
Z
The new transponder code must be
different from existing transponder
codes.
• Press the key below the "Confirm"
symbol (96).
The new transponder code is
displayed.
Z
If the wrong transponder has been
used, delete it, see page 166, and add
a correct transponder.
To return to the main menu, press the key below the "Back" symbol (97).
A new transponder has been added.
93
96
97
100
92
99
55
Z
The transponder codes saved are sorted first of all numerically and then
alphabetically.
165
04.19 en-GB