3. Use a Philips screwdriver to loosen the captive screws located at the top and bottom of the module
panel.
4. If the module has ejector handles, press the red release buttons, and pull the ejector handles outward
to the open position.
5. Carefully slide the module out of the chassis.
6. Place the module in its antistatic bag, being careful not to touch module components, pins, leads or
solder connections.
7. Cover the empty chassis slot with a blank filler panel, and tighten the filler panel's captive screws using
a Phillips screwdriver. Turn both screws several times before tightening them completely.
RELATED DOCUMENTATION
Installing a CTP Interface Module, Processor Module, or Clock Module | 65
CTP2000 T1/E1 Interface Module
CTP2000 Clock Interface Modules
Cabling the CTP2000 Platform Overview
T1/E1 Interface Module Pinouts
Installing or Removing a CTP150 CompactFlash Card
The CompactFlash card is installed in the rear panel of the CTP150. To remove or install the CompactFlash
card:
1. Power off the unit.
2. Remove the CompactFlash face plate in the center of the rear panel by unscrewing the two retaining
screws.
3. Remove or install the CompactFlash card in the flash socket.
4. Replace the face plate with the two retaining screws.
67
To Next Page
Loading...
Need help?
General
