Required Tools, Wires, and Cables for the CTP150 Platform | 70
Setting Up Management Access to the CTP150 Platform | 75
CTP150 Console Port Setup
Cabling a CTP150 Interface Module | 71
Required Tools, Wires, and Cables for the CTP150 Platform
Cabling your device takes only a few minutes. You need the following items and the cables listed in
Table 10 on page 70 for proper installation:
•
1/8-inch flathead screwdriver
•
3/8-inch wrench or 3/8-inch nut-driver
•
No. 2 Phillips screwdriver
•
Ground wires—We recommend a minimum of 18-AWG ground wire for AC and DC-powered versions,
if applicable.
•
Two #10 kep nuts (supplied) to connect the ground (earth) wire to the ground terminal.
•
Power module wiring—We recommend a minimum of 18-AWG wire for the device with a dual stud
terminal lug with 5/8-inch spacing.
Consider the distance from the connection point and the configuration of the device when determining
the size of wire used.
Table 10: Required Cables
Port and Cable UsedConnection
One 10/100Base-T Ethernet management port with an
RJ-45 connector.
Management connection between the processor module
and the LAN
One RS-232 port with a DB-9 connector for VT100
management access.
Management connection between the processor module
and a management console
Cables vary depending on module.Direct connections to interface modules
For more information about CTP150 Series cable and pinout specifications, refer Cable and Pinout
Specifications.
RELATED DOCUMENTATION
70
To Next Page
Loading...
Need help?
General
