Juniper CTP Series Hardware Guide

CHAPTER 14
Accessing the CTP150 Platform
IN THIS CHAPTER
Setting Up Management Access to the CTP150 Platform | 75
Connecting Directly to the CTP150 Platform | 75
Using HyperTerminal to Access the CTP150 Device | 76
Using SSH to Access the CTP Platform | 77
Setting Up Management Access to the CTP150 Platform
Before you power on the device for the first time, you need to physically connect a console (PC, Macintosh,
or UNIX workstation) to the device’s CONSOLE port. Through this connection, you communicate with
the CTP150 device during the power-on process to set an IP address and initially configure the device.
After you configure an IP address on the CTP150 device, you can access the device remotely through the
Ethernet port by running SSH from a remote console.
RELATED DOCUMENTATION
Connecting Directly to the CTP150 Platform | 75
Using HyperTerminal to Access the CTP150 Device | 76
Using SSH to Access the CTP Platform | 77
Connecting Directly to the CTP150 Platform
You can connect a console terminal (PC, Macintosh, or UNIX workstation) directly to the CONSOLE port
on the CTP150 device. Initial configuration of the CTP device requires a direct connection. Once you
configure an IP address for the device, you can connect to the device remotely.
75

Juniper CTP Series Specifications

General

Brand	Juniper
Model	CTP Series
Category	Server
Language	English