To Next Page

To Previous Page

For example:

***** First boot of this flash. Setting up basic system configuration. *****

*********** Setting up the root password ************

Changing root's password!

Changing password for user root.

New password:

Retype new password:

BAD PASSWORD: it is too short

passwd: all authentication tokens updated successfully.

Backing up /etc to nonvolatile storage..

************** Setting up the network ***************

Configure supported protocols:

0) IPv4 Only

1) IPv6 Only

2) IPv4 & IPv6

Please select your option (rtn for 0):

There are 2 ethernet devices available for use. The default device

is the device through which the default gateway can be accessed.

Ctp circuits can run over any ethernet device, default or not.

A default device must be configured, other devices may be configured

and enabled, or disabled. Here is a list to the available devices

and their descriptions:

eth0: 10/100/1000 Copper (right)

eth1: 10/100/1000 Copper (left)

What device would you like to make the IPV4 default device? (rtn for eth0):

OK, eth0 (10/100/1000 Copper (right)) will be configured as IPV4 default device.

Please input the hostname (return for (none)): ctp150bot

===== Configuration for eth0 (default device):

Please input the ip (return for 127.0.0.1): 10.3.206.10

Please input the netmask (return for 255.255.255.0): 255.255.0.0

Please input the gateway (return for 127.0.0.1): 10.3.0.1

Please input the mtu in bytes (return for 1500):

Add route to interface eth0 [n]

Juniper CTP Series Hardware Guide

Other manuals for Juniper CTP Series