23
Chapter 2
Installing and Connecting a Device
This chapter describes how to install an SSG 500M Series device in a standard
19-inch equipment rack and how to connect cables and power to the device. This
chapter includes the following sections:
“Before You Begin” on page 24
“Installing Equipment” on page 24
“Connecting Interface Cables to a Device” on page 26
“Chassis Grounding” on page 26
“Connecting the Power” on page 26
“Powering a Device On and Off” on page 29
“Connecting a Device to a Network” on page 30
NOTE: For safety warnings and instructions, refer to the Juniper Networks Security
Products Safety Guide. Before working on any equipment, you should be aware of
the hazards involved with electrical circuitry and you should be familiar with
standard practices for preventing accidents.
To Next Page
Loading...
Need help?
General
