Juniper SSG 520M User Manual

WAN PIM Configuration  45
To configure the E1 interface, use the WebUI or CLI as follows:
WebUI
Network > Interfaces > List > Edit (interface): Enter or select the applicable
option value, then click OK.
WAN Configure: main link
WAN Encapsulation: PPP
Click Apply.
Binding a PPP Profile: junipertest
IP Address/Netmask 172.18.1.1/24
CLI
set interface serial1/0 encapsulation ppp
set ppp profile “junipertest” static-ip
set ppp profile “junipertest” auth type chap
set ppp profile “junipertest” auth local-name “juniper”
set ppp profile “junipertest” auth secret “password”
set interface serial1/0 ppp profile “junipertest”
set interface serial1/0 ip 172.18.1.1/24
set user “server” type wan
set user “server” password “server”
save
T3 Interface
T3, also known as data signal 3 (DS3), is a high-speed data-transmission medium
formed by multiplexing 28 DS1signals into seven separate DS2 signals and
combining the DS2 signals into a single DS3 signal. T3 links operate at
43.736 Mbps.
The DS3 PIM supports the following standards:
 ANSI T1.107, T1.102
 Telcordia GR 499-CORE, GR 253-CORE
 Telcordia TR-TSY-000009
 AT&T Technical Reference 54014
 ITU G.751, G.823

Juniper SSG 520M Specifications

General

Brand	Juniper
Model	SSG 520M
Category	Gateway
Language	English