Unpack and Mount an SSR130
IN THIS SECTION
Unpack an SSR130 | 28
Verify Parts Received with the SSR130 | 29
Register Products—Mandatory to Validate SLAs | 30
Mount an SSR130 on a Desk or Other Level Surface | 30
Mount an SSR130 on a Two-Post Rack | 31
Installing Antennas for the SSR130 Appliances that Support LTE | 33
Inserting the SIM Card | 34
Unpack an SSR130
The SSR130 is shipped in a cardboard carton and secured with foam packing material. The carton also
contains an accessory box and quick start instructions.
NOTE: The SSR130 is maximally protected inside the cardboard carton. Do not unpack it until
you are ready to begin installation.
To unpack the SSR130:
1. Move the cardboard carton to a staging area as close to the installation site as possible, where you
have enough room to remove the components from the chassis.
2. Position the cardboard carton with the arrows pointing up.
3. Carefully open the top of the cardboard carton.
4. Remove the foam covering the top of the SSR130.
5. Remove the accessory box.
6. Verify the parts received against the lists in Table 13 on page 29.
28
To Next Page
Loading...
Need help?
General
