Do not use multipurpose Type ABC chemical fire extinguishers (dry chemical fire extinguishers). The
primary ingredient in these fire extinguishers is monoammonium phosphate, which is very sticky and
difficult to clean. In addition, in the presence of minute amounts of moisture, monoammonium phosphate
can become highly corrosive and corrodes most metals.
Any equipment in a room in which a chemical fire extinguisher has been discharged is subject to premature
failure and unreliable operation. The equipment is considered to be irreparably damaged.
NOTE: To keep warranties effective, do not use a dry chemical fire extinguisher to control a fire
at or near a Juniper Networks device. If a dry chemical fire extinguisher is used, the unit is no
longer eligible for coverage under a service agreement.
We recommend that you dispose of any irreparably damaged equipment in an environmentally responsible
manner.
Laser and LED Safety Guidelines and Warnings
IN THIS SECTION
General Laser Safety Guidelines | 68
Class 1M Laser Product Warning | 69
Class 1M Laser Radiation Warning | 69
Class 1 Laser Product Warning | 70
Class 1 LED Product Warning | 71
Laser Beam Warning | 72
Unterminated Fiber-Optic Cable Warning | 73
Juniper Networks devices are equipped with laser transmitters, which are considered a Class 1 or Class 1M
Laser Products by the U.S. Food and Drug Administration and are evaluated as a Class 1 Laser Product
per EN 60825-1 and EN 60825-2 requirements.
Observe the following guidelines and warnings:
67
To Next Page
Loading...
Need help?
General
