The SSR130 appliances are configured from an existing Session Smart Router (SSR) Conductor.
Configure the SSR130 Appliance from the SSR Conductor
The SSR Conductor is an instance that is used to manage the appliances you configure within the same
Authority. It offers centralized administration, provisioning, monitoring, analytics, and lifecycle management
of the appliances.
The Authority is where system-wide data is stored. Conceptually, the Authority represents the complete
set of all appliances managed under a single organizational entity
Using the SSR Conductor, the following procedures guide you through SSR130 appliance configuration.
The names and IP addresses used here are for example only.
Create the SSR Appliance
1. Log in to the Conductor GUI.
2. Select Configuration.
3. In the Routers list, select ADD.
4. Name the new SSR appliance_dallasbr2_ and select SAVE.
•
Input the location _Coordinates_: +32.7767-096.7970/.
•
Select internal for Inter-node Security Policy.
Create the WAN Interface
1. Scroll down to Nodes and select ADD next to Nodes.
a. Name the node, _node1_ and select SAVE.
b. Select the Role of Combo for the node.
2. Scroll down and select ADD next to Device Interfaces.
a. Name the Device Interface _wan1_ and select SAVE.
b. Select Ethernet for Device Interface Type.
c. Enter the PCI address of the interface to be used as the WAN interface under PCI Address. To
identify the PCI Address, refer to [Identify Interface PCI
Addresses](intro_system_reqs.md#identify-interface-pci-addresses).
3. Scroll down to Network Interfaces and select ADD.
a. Name it _wan1_ and select SAVE.
41
To Next Page
Loading...
Need help?
General
