31
5 Maintenance
You can initiate the rinse operation manually at any time.
Precondition:
ESPRESSO is displayed (example).
T Place a receptacle under the coffee spout.
O T Touch the P symbol for approximately 2 seconds until
RINSE appears on the display.
k T Press the Rotary Switch to enter the program item.
RINSE
k T Press the Rotary Switch to initiate the rinse operation.
RINSING, water flows out of the coffee spout.
The rinse stops automatically.
ESPRESSO appears on the
display (example).
E This chapter applies to the professional fine foam frother and
the fine foam frother.
To ensure that the fine foam frother always works properly, you
must rinse it with water after every milk preparation.
Your IMPRESSA will not prompt you to rinse the fine foam frother.
Precondition:
ESPRESSO is displayed (example).
T Remove the milk pipe from the milk container or carton.
T Fill a receptacle with 8.5 oz (250 ml) of fresh water.
T Immerse the milk pipe in the receptacle.
T Place a receptacle under the fine foam frother.
n T Touch the Steam symbol.
HEATING/ STEAM
As soon as the machine has heated up, STEAM/ READY
appears, the light segment on the switch lights up.
h T Turn the switch to them position.
STEAM appears and the fine foam frother and the milk
pipe are rinsed with fresh water.
j T When clean water starts to flow out of the frother, turn the
switch back to the oposition.
STEAM/ READY
The rinsing of the fine foam frother is now complete.
Rinsing the machine
Rinsing the fine foam
frother
To Next Page
Loading...
Need help?
General
Weight and Dimensions
