Inserting an SD Card
Insert a commercially available SD card before recording.
This unit
comes with two SD card slots. When two SD cards are inserted and
“SEAMLESS RECORDING” in the “RECORD SETTING” menu is set to “ON”
, recordings can be continued on the other card even if one card is full or
error occurs on one card.
“Types of Usable SD Card” (A p. 7)
“Approximate Video Recording Time” (A p. 44)
0
By default, files are recorded to the SD card in slot A. To record to the SD
card in slot B, change the “REC VIDEO TO SLOTS” or “REC STILLS TO
SLOTS” setting.
“ REC VIDEO TO SLOTS ” (A p. 110)
“ REC STILLS TO SLOTS ” (A p. 110)
1
Set the “STANDBY/ON OFF” switch to “OFF”.
.
2
Open the door.
.
0
Slide the “DOOR LOCK” lever to the left, and pull the door towards
you.
3
Insert an SD card into slot A.
.
0
Insert with the label facing upwards.
4
Close the door.
.
0
After closing the door, slide the “DOOR LOCK” lever to the right to
lock the door.
Warning
0
Make sure not to insert the card in the wrong direction.
It may cause damage to the unit and card.
0
Turn off the power of this unit before inserting or removing a card.
0
Do not touch the metal contact area when inserting the card.
Memo :
0
When “SEAMLESS RECORDING” is set to “ON”, recordings can still be
made to
the other SD card without stopping when the remaining recording
time on recording SD card runs out or when error occurs on the current
recording media.
“SEAMLESS RECORDING (Seamless recording/Auto recovery recording)”
(A p. 99)
0
Both videos and still images can be recorded on one SD card. It is
recommended to confirm the video operation of the SD card before usage.
0
To use cards that have been used on other devices, it is necessary to
format (initialize) the card using “FORMAT SD CARD” from media
settings.
“ FORMAT SD CARD ” (A p. 110)
Removing the Card
Push the SD card inward once, then pull it out straight.
.
Getting Started
6
To Next Page
Need help?
General
