3 ．
．．
． P e r m i t a n d f or bi d
Permit
i. Use special tool to remove and install
bearing
ii. Use special tool to install oil seal
iii. Keep the free clearance between braking
levers and throttle handlebar, between
braking rocker arm and throttle handlebar.
iv. Use recommended lubrication on appointed
lubricating parts.
v. Replace whole set of taper rolling bearing of
front fork if necessary.
vi. Yellow marks of tyres must be dead against
valve port.
vii. Ensure there are no jam-up, crispation, and
distortion, and keep all oil hoses smooth.
viii. When installing disc brake caliper, ensure
brake disc between braking shoes.
Keep tire with normal air pressure.
Forbid
1． It is forbidden to operate front disc braking
lever when removing disc or caliper.
2． Never place front disc on ground. Otherwise
disc may be damaged.
3． When brake shoe or brake pad kit is abraded
to its mark level, never go on using it.
4． Never add disc brake oil to brake cyliner
exceeding the position of “ UPPER
LEVEL”.
5． Never polish disc with sand paper.
6． It is forbidden to reuse hatch pin, seal ring,
paper gasket etc.
7． Never delay to replace damaged chain.
Replace it at once if chain is damaged.
8． Never start vehicle without muffler.
To Next Page
Loading...
Need help?
General
