Keithley 2302 User Manual

SCPI Tables 12-7
:SENSe[1]
:PCURrent
:TIME (cont.)
:HIGH? Query high integration time.
:LOW <NRf> Specify integration time (in sec) for low pulse
measurements
(33.33E-06 to 0.8333) — accounts
neither for internal trigger delay nor user delay.
3.333E-05
:LOW? Query low integration time.
:AVERage <NRf> Set integration time in seconds for measurement of
pulse A
VERage time — accounts neither for
internal trigger delay nor user delay.
3.333E-05
:AVERage? Query average integration time.
:DIGitize <NRf> Specify integration time (in sec) for digitizing or burst
measurements; 33
.33e-6 to 0.8333.
3.333e-5
:DIGitize? Query integration time for digitizing or burst
measurements.
:STEP <b> To perform a series of step measurements, se
t to ON. OFF
:STEP? Query state for performing step measurements.
:UP <NRf> Specify number of UP steps <0-20> (max is for both
up and do
wn combined).
1
:UP? Query number of UP steps specified.
:DOWN <NRf> Specify number of DOWN steps <0-20> (max is for
both
up and down combined).
1
:DOWN? Query number of DOWN steps specified.
:TIME <NRf> Specify step integration time for UP plus DOWN
ste
ps: 33.3µsec–100msec.
200μsec
:TIME? Query step integration time specified for UP plus
DO
WN steps.
:TimeOUT
<NRf>
Step TimeOUT (other than the first step):
2msec–200msec.
2ms
:TimeOUT? Query step TimeOUT setting for all steps but the first
ste
p.
:INITial <NRf> TimeOUT for the first step: 10msec–60secs. 2sec
:INITial? Query TimeOUT setting for the first step.
Table 12-4 (cont.)
SENSe command summary (refer to Tables 2-3, 3-2, and 4-2) (cont.)
Command Description
Default
parameter
SCPI
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com

Keithley 2302 Specifications

General

Brand	Keithley
Model	2302
Category	Power Supply
Language	English